SEAGATE TECHNOLOGY, INC.

SIDEWINDER 200 EXTERNAL

Device Type             External Tape Drive
Interface               SCSI-2 Fast/Wide
Format                  AIT-1
Sustained Transfer Rate 3MBPS (Native), 6 to 9GB (Compressed)
Size                    5.25 in. half height
View                    Bottom


                              DRIVE SELECT ID

  Note:To select the SCSI ID, press SW1 until the ID you desire is shown
  in the switch viewer. The address is shown in hexadecimal.

                        USER CONFIGURABLE SETTINGS

                  Setting                     Label         Position

  »   Parity check enabled                    JP1/1           Open

      Parity check disabled                   JP1/1          Closed

  »   Factory configured - do not alter       JP1/2       Unidentified

  »   Factory configured - do not alter       SW2/1       Unidentified

  »   Factory configured - do not alter       SW2/2       Unidentified

  »   Factory configured - do not alter       SW2/3       Unidentified

  »   Factory configured - do not alter       SW2/4       Unidentified

  »   Data compression enabled                SW2/7            On

      Data compression disabled               SW2/7           Off

  »   Factory configured - do not alter       SW2/8            On

                      MANUFACTURERS RECOMMENDED MEDIA

       Tape              Capacity Without       Capacity With Compression
                           Compression

       AIT-1                  100GB                      200+ GB


                             DIAGNOSTIC LED(S)

   LED           Color           Status               Condition

   LED1      Unidentified          On              Unit power is on

   LED1      Unidentified         Off             Unit power is off

   LED2          Green             On         SCSI interface is ready for
                                                    data transfer

   LED2          Green            Off            Drive is not in use

   LED2          Green          Blinking       Drive is either searching
                                             for data, reading/writing to
                                             tape, or rewinding the tape

   LED3          Green             On          Cartridge is loaded into
                                                        drive

   LED3          Green          Blinking      Cartridge is unloaded from
                                                        drive